Connecting the Debug Board through Com Port 1 of Host PC

Insight3fl at 02h06
20
Jul
2010
Connecting the Debug Board through Com Port 1 of Host PC

I am trying to connect to the Debug board in windows PC using Hyper terminal through com 1. I have serial cable connected but do not see any data in terminal. Can you please advise proper set up?
Thanks
About
This topic belongs to the forum
  • Numbers of topics : 1006
  • Numbers of messages : 4570
  • Numbers of users : 877
  • Numbers of points : 559
Similar topics
Odroid, I am a little confused. What is the difference between connecting USB via the supplied cable (TA20 to USB) and using the Debug board and connecting the Debug board to the pc via a mini usb connector to board and then to pc? When I tried the Debu
Hi, New images of the new connector: TTA20 to USB Host board:Standard A type connector. Connect various external accessories such as GPS, camera, keyboard, external HDD, etc Thanks, Alvaro
I need to debug ODROID kernel (through COM). I downloaded sources of kernel from http://dev.odroid.com/gitroot/linux.git with git clone command. I have built all branches ( master, c100-29_0, next-c100 ), wrote them to ODROID and tried to boot with them
Hi, I started to play with Media Companion 3.019 running under Vmware Fusion on a MacBook Pro. Mc scrapes my test movies located in a shared folder on the mac, it creates the video_ts.nfo file, and it places them in the correct locations. These
Just wondering if there is a recommended port based vlan switch to go with my ESR-9850 router. So the setup would be like this Fiber modem > port based vlan switch > ESR-9850 router I only require 5 ports for the switch, and also that i
Forums from same category
See also
more_less
Informations

12 Replies For the topic :
"Connecting the Debug Board through Com Port 1 of Host PC"

This topic has been viewed 907 times.

Last message :
20/07/2010 at 02h06 by "Insight3fl"