Where is the interrupt number mapping for GPIO?

riccati at 02h53
24
Nov
2010
Where is the interrupt number mapping for GPIO?

In the older kernel 2.6.29, the mapping for s5pc110 gpio port and their corresponding interrupt numbers can be found in arch/arm/plat-s5pc11x/include/plat/irqs.h. In the new kernel 2.6.32, where can I found the similar mapping?

Regards
About
This topic belongs to the forum
  • Numbers of topics : 1006
  • Numbers of messages : 4570
  • Numbers of users : 877
  • Numbers of points : 559
Similar topics
Hi, Does GPIO in S5PC110 controlled by block or can be controlled seperately? For example GPH3 Control registers or GPH3CON[1, can it be controlled independently from GPHCON[4]. Because I've encountered other uP wherein GPIOs are contorlled by
Mapping drive merupakan suatu cara untuk mempermudah user dalam mengakses folder yang telah di share nee tutorialnya: http://www.microsoft.com/windowsxp/using/networking/maintain/mapdrive.mspx atau
I came here with The Seldom Seen Kid under my arm and it wasn't long before the great and the good here were recommending I try out eariler works by the band. My wife recently bought me Leaders Of The Free World and Cast Of Thousands and I've been slowly
Hello I do a nice acoustic version of this with the capo on the 4th fret. I think Elbow do it on the 3rd/ 2nd fret. Have a mess around see what's best for you. Em D A Don't
Hi all, I'm having an issue with an employee dimension whereby the typical natural key (employee id) is not durable. That being the case, and not being able to use the name as a natural key, I'm a bit stuck as to what I should use for a business key in
Forums from same category
See also
more_less
Informations

2 Replies For the topic :
"Where is the interrupt number mapping for GPIO?"

This topic has been viewed 569 times.

Last message :
24/11/2010 at 02h53 by "riccati"