Unable to disable -oneunit mode

TrooP at 10h15
02
Oct
2010
Unable to disable -oneunit mode

Hi... im running both the SMP and GPU2 clients through your software *which is awsome btw Wink*
BUT for some reason it always starts the clients with the -oneunit flag eventho i havent clicked it!
i have tried clicking it and starting but that just give me tha same result... :/

my spec:

Cpu: Amd Phenom2 x4 940
MB: Asus Crossh
About
This topic belongs to the forum
  • Numbers of topics : 282
  • Numbers of messages : 1069
  • Numbers of users : 254
  • Numbers of points : 99
Similar topics
Brand new Sylvania right out of the box...Wifi wont stay on..actually never picks up anything....Firmware is DG2.01...Since I cant access internet can I download the 2.02 version onto an SD card....I tried to exchange but locations in my area are out of
**WARNING** The Recovery mode I wouldn't use that unless it was the last resort or you had issues flashing the firmware (Example (router rebooting on it's own, stuff like that). Note You'll need to set your computer to the same subnet mask. Now you'l
I am using the current version 3.317 and I can not figure out how to remove a tv show. I have deleted some shows and or moved them to a new location. In the Main Browser window I now get. Unable to find folder: Thanks in advance
TLWR1043ND TX: 20dBm = 100mW for Wireless Atheros 400MHz WNPU, 32MB of RAM, 4MB for FLASH.
I spend 4 hours flashing every rom for my epad. All these roms and either the screen wouldn't work or the wifi was unable to start. I am at a loss anyone have any suggestions?
Forums from same category
See also
more_less
Informations

4 Replies For the topic :
"Unable to disable -oneunit mode"

This topic has been viewed 441 times.

Last message :
02/10/2010 at 10h15 by "TrooP"